Search Results - VWVortex
Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    Fourtitude.com


    Search:

    Type: Posts; User: DbilasTDI

    Page 1 of 12 1 2 3 4

    Search: Search took 0.05 seconds.

    1. Replies
      7
      Views
      282

      16V 020 clutch rod? new clutch issues

      Rabbit truck with 16V swap and 16V trans.
      old clutch disk center started coming apart and a little chunk of the center metal was stuck between the disk and the flywheel.
      Installed a South Bend...
    2. 25 years ago Jeff Moss/Aaron/Velocity did a 1.6TD...

      25 years ago Jeff Moss/Aaron/Velocity did a 1.6TD with clipped exhaust wheel on an ABA with Electromotive TEC. It made impressive power. European Car did a thing on it back in the day.
    3. Replies
      2
      Views
      406

      Drain the tank If it is nasty at all replace it....

      Drain the tank If it is nasty at all replace it. I would go for a non electronic early CIS and get rid of the sensor and ECU.
    4. there is a circuit board in the speedo cluster...

      there is a circuit board in the speedo cluster that transmoglifys the dual sensor output and provides input to the gauge.
    5. Replies
      4
      Views
      286

      something loose in the tank?

      something loose in the tank?
    6. look for a split in the big air boot: makes for a...

      look for a split in the big air boot: makes for a variable leak.
    7. Replies
      2
      Views
      415

      You do not have a pan problem, you have a...

      You do not have a pan problem, you have a crankcase pressure problem. This is common on NA hot 16V as well. You need a vacuum pulling from the crankcase and the valve cover and puke tanks, pull...
    8. Replies
      1
      Views
      512

      You need a 2.0 16V auxillary shaft and oil pump...

      You need a 2.0 16V auxillary shaft and oil pump gear
      You need a block off plate for the block vent which you need to vent.

      You can use the ABA pistons, etc and get a 9:1 ish compression or get...
    9. Thread: Decarb

      by DbilasTDI
      Replies
      3
      Views
      463

      Thats on the front of the crank. You manually...

      Thats on the front of the crank. You manually rotate the engine by hand with a wrench. Have you considered: ...
    10. Thread: Decarb

      by DbilasTDI
      Replies
      3
      Views
      463

      suck it out with a shop vac.

      suck it out with a shop vac.
    11. Replies
      7
      Views
      518

      Has your cat had a meltdown?

      Has your cat had a meltdown?
    12. 1. All the 1.8 and 2 liters and more have the...

      1. All the 1.8 and 2 liters and more have the same water pump so yes

      2, Yes, stock 16V pulley.
    13. Replies
      42
      Views
      1,576

      No need to burn chips with megasquirt. You can...

      No need to burn chips with megasquirt. You can tune the map while you drive it. And much better spark with an EDIS ignition.
    14. your cat is melting down from it being too rich...

      your cat is melting down from it being too rich and too old
    15. Replies
      1,504
      Views
      677,067

      Sticky: yea but don't go for the long 2-piece ones as you...

      yea but don't go for the long 2-piece ones as you run out of room fast. The Weber manifold is a tight fit, but for the best.
    16. Replies
      42
      Views
      1,576

      MegaSquirt + EDIS or Megajoltlt JR, crank...

      MegaSquirt + EDIS or Megajoltlt JR, crank trigger, map sensor with a 3D ignition map would be much better spark with full control.
    17. Replies
      2
      Views
      432

      Mount the alternator like a 16V G60.

      Mount the alternator like a 16V G60.
    18. Replies
      2
      Views
      568

      :thumbup::thumbup:

      :thumbup::thumbup:
    19. Replies
      5
      Views
      680

      Franks TDI in Missouri seems to have a great...

      Franks TDI in Missouri seems to have a great reputation.
    20. Replies
      1
      Views
      306

      200 easy, rods would be the only thing to...

      200 easy, rods would be the only thing to upgrade. My buddy did a compound setup on stock rods and Hans Cheenese pistons. no problem
    Results 1 to 20 of 238
    Page 1 of 12 1 2 3 4