Search Results - VWVortex
Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    Fourtitude.com


    Search:

    Type: Posts; User: Newparts.com

    Page 1 of 6 1 2 3 4

    Search: Search took 0.10 seconds.

    1. Check for broken wires in the rubber boot going...

      Check for broken wires in the rubber boot going to the hatch.
    2. This is usually a sign that you're losing...

      This is usually a sign that you're losing pressure in the clutch hydraulic circuit. Check the clutch master and slave cylinders for any signs of external leakage. You may also have air in the system,...
    3. Replies
      4
      Views
      409

      Check for leaks in the crankcase ventilation...

      Check for leaks in the crankcase ventilation hoses under the intake manifold. Especially the large elbow going into the oil separator.
    4. It is gauge pressure, so if the gauge is not...

      It is gauge pressure, so if the gauge is not connected to anything and it is reading atmospheric pressure it will show 0. When you put it into the dipstick tube the needle should only drop a...
    5. You can check the crankcase vacuum by inserting a...

      You can check the crankcase vacuum by inserting a vacuum gauge into the dipstick tube with the engine running at idle. There should be a very slight vacuum on the crankcase, the needle should move...
    6. If you have the 09G transmission both the G182...

      If you have the 09G transmission both the G182 input speed and G195 output speed sensors are located inside the transmission above the valve body. The valve body will need to be removed to access...
    7. Replies
      9
      Views
      985

      Have you tried to clean the throttle body and do...

      Have you tried to clean the throttle body and do a basic setting?
    8. Replies
      2
      Views
      4,963

      The oxygen sensor code has to do with the heater...

      The oxygen sensor code has to do with the heater circuit for the oxygen sensor, it has nothing to do with the cat. It is the upstream sensor on the right hand side of the engine, passenger side of...
    9. Replies
      5
      Views
      1,310

      The P0341 could originally have set from the belt...

      The P0341 could originally have set from the belt being stretched a bit, among other things. I would suspect this if the belt has any slack in it. It only takes a slight amount of variance between...
    10. Are you planning on replacing the whole pump and...

      Are you planning on replacing the whole pump and modulator, or just the electrical portion(ABS control module)? No communication errors usually only require the electrical control module to be...
    11. Your resistance readings are correct. For TT MY's...

      Your resistance readings are correct. For TT MY's up to 05/02 high resistance indicates a full tank, and low resistance indicates an empty tank. After 05/02 Audi changed this and the opposite is the...
    12. Replies
      3
      Views
      537

      Sounds like you are describing a throw out...

      Sounds like you are describing a throw out bearing noise.
    13. Replies
      5
      Views
      1,310

      I have had an issue with a similar situation. The...

      I have had an issue with a similar situation. The cam sensor had been replaced, and I had to scope the cam and crank sensor signals while moving the distributor to get them perfectly aligned. The two...
    14. Replies
      2
      Views
      1,129

      Check for a RPM signal on the tach and the...

      Check for a RPM signal on the tach and the scanner while cranking. No RPM signal points to a faulty crank position sensor.
    15. You don't always get more for paying more. You...

      You don't always get more for paying more. You can swear OEM all you want, but let's face it; Each brand tries to reinvent the wheel. It might be because of copyright issues or because they think...
    16. Replies
      12
      Views
      2,414

      I checked a few parts to make sure, so I...

      I checked a few parts to make sure, so I apologize if they aren't up for every listing, but Genuinenewparts.com has wire diagrams. You can either search by car and narrow categories down until they...
    17. Genuinenewparts.com actually sells the part for...

      Genuinenewparts.com actually sells the part for about the same as ECS (~130), but I'm not sure how the shipping would compare.

      That's still crazy for what the part is. Buy one, make a mold, buy...
    18. Replies
      7
      Views
      858

      They are all off of our newest site;...

      They are all off of our newest site; Partbull.com. We actually have another site as well (genuinenewparts.com), but I neglected to think to check there, honestly. I don't know how the prices compare...
    19. Replies
      102
      Views
      7,324

      Asking the important questions, haha. Then I...

      Asking the important questions, haha. Then I guess I would upset you fine gentlemen all for not! Lets hope your sacrifices weren't in vain.
    20. Replies
      102
      Views
      7,324

      I understand that it is annoying, friend. I...

      I understand that it is annoying, friend. I apologize, as for most other places we were able to do this, we had a "General Posts" or "Vendor Forum" with enough outreach that we posted there to let...
    Results 1 to 20 of 118
    Page 1 of 6 1 2 3 4