Search Results - VWVortex
Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    Fourtitude.com


    Search:

    Type: Posts; User: vtraudt

    Page 1 of 67 1 2 3 4

    Search: Search took 0.39 seconds.

    1. Replies
      7
      Views
      193

      N75 operation

      Is the wastegate OPEN (i.e. no boost) with VACUUM applied or PRESSURE to the actuator on the turbo?
      Does anybody have the setup instructions for adjusting the wastegate (actuator/turbo, 2 nuts to...
    2. Replies
      7
      Views
      193

      When running output test, there is vacuum on the...

      When running output test, there is vacuum on the N75 (cycling on/off as the output test switches between 95 and 5 % duty cycle).

      Will get underneath with engine running and output test running to...
    3. Replies
      7
      Views
      193

      Ran output test with VAGcom. Changes sound and...

      Ran output test with VAGcom. Changes sound and N75 duty cycle, I assume as it should.
      Tested the actuator on the turbo, holds vacuum. Lever/actuator moves when applying vacuum.

      Any suggestion...
    4. Replies
      7
      Views
      193

      Thanks. Will do shortly. I didn't mess with N75...

      Thanks. Will do shortly.
      I didn't mess with N75 per se (or anything on top of the engine), just had pulled the vac hose off the old turbo/actuator.

      Best way to check if N75 is the problem?
    5. Replies
      7
      Views
      193

      BEW - no boost - used turbo

      I replaced my turbo with a used identical one (very tight, lever moving).
      Reused my actuator (tested, not leaking).
      After installation, car runs fine, no leaks.
      I can hear turbo spooling...
    6. Aside from above mentioned (I am inquiring with...

      Aside from above mentioned (I am inquiring with him), are other source that offer the re-flashing?
    7. Thanks for the tip. Sent him an email. Will see...

      Thanks for the tip. Sent him an email. Will see if he answers (on his site, he indicates he might be too busy to respond).
    8. Interchange to LTK transmission or mechatronic/valve body?

      2010 CC 2.0T DSG. Want to change the transmission (or just the valve body/mechatronic).
      I have LTK transmission code (and error code pressure control solenoid 1 code 17130 P0746).

      Are there...
    9. 2006 Bentley Continental GT - exhaust flap

      Is there a way to actuator the exhaust flap manually?
      Or has someone modified to make manual control possible?

      Also interested for the W12 Continental.
    10. Replies
      0
      Views
      262

      GT V8 dual batteries - which is "primary"

      I have large battery on left side of trunk, smaller on right.
      Last week, car would not start.
      Found left (larger) low on voltage, right was fine.
      When calling for replacement battery quotes,...
    11. bump for any ideas how to continue with...

      bump for any ideas how to continue with troubleshooting.

      Any suggestions what might be the cause?
    12. Replies
      3
      Views
      3,801

      In this context: my 2006 Continental had a large...

      In this context: my 2006 Continental had a large battery on the left, and smaller battery on the right (in the trunk).
      Which is considered the MAIN battery?

      To charge/maintain with just ONE...
    13. 2010 CC - 17130 - Pressure Control Solenoid 1 - P0746

      My 2010 Passat CC 2.0T FWD sometimes does not shift out of P. Transmission module shows code:

      17130 - Pressure Control Solenoid 1 - P0746 - 012 - Implausible Signal or Stuck Off - Intermittent
      ...
    14. Replies
      16
      Views
      1,171

      VERY nice. This is what I would like to do. ...

      VERY nice.
      This is what I would like to do.
      What 'doors' did you used?

      If you find the link on vortex, can you link me?
    15. Overboost code coming back

      The overboost code has been coming back (this time also misfires codes in both ECU).

      Does anybody have practical suggestions to 'smoke' (pressure test) the GT?
      My 'smoker' has a large rubber...
    16. Replies
      16
      Views
      1,171

      Interesting. Does anyone have details of the...

      Interesting.
      Does anyone have details of the OEM design/connection?
    17. Replies
      16
      Views
      1,171

      Looks good! But how did you CONNECT (as in LOAD...

      Looks good!
      But how did you CONNECT (as in LOAD bearing/force) the strut? That mechanism does not appear to be an easy DIY?
      Or did you weld it in place?

      If not connected solid, the strut...
    18. Replies
      16
      Views
      1,171

      I know him and saw his offering (also on ebay)....

      I know him and saw his offering (also on ebay). Roughly $600 shipped. Don't want to spend that kind of money.
    19. Rear Seat Delete Strut Bar DIY

      Any DIY links for making a rear seat delete strut bar?
    20. Replies
      16
      Views
      1,171

      Rear seat delete

      Any good DIY links for the rear seat delete?
    Results 1 to 20 of 1328
    Page 1 of 67 1 2 3 4